index :: seq

seq.phasor

control rate phasor (saw) generator

available since version: 0.9.1

---

information

Outputs saw signal in [0..1] or [0..1) range. Note: control rate in PureData depends on block size and samplerate. Do not rely on strict timing for this object, especially at high frequencies!

arguments:

• FREQ frequency
  type: float
  units: Hz
  

methods:

• phase set current phase
  parameters:
  • [VALUE] new phase value
    type: float
    

• reset reset phase and stop
  

• rewind reset phase without stopping
  

• start start from current position
  

• stop stop
  

• tick output current value and move to next
  

properties:

• @freq Get/set frequency
  type: float
  units: Hz
  range: 0..100
  default: 0
  

• @on Get/set on/off state
  type: bool
  default: 0
  

• @invert Get/set saw inversion mode. If true, outputs descreasing waveform
  type: bool
  default: 0
  

• @steps Get/set numbers of steps
  type: int
  min value: 3
  default: 128
  

• @open Get/set output in open [0..1) range, otherwise output range is [0..1]
  type: bool
  default: 0
  

inlets:

• 1: starts output, 0: stop
  type: control
• reset phase to 0
  type: control

outlets:

• float value in 0..1 range
  type: control
• bang after full cycle
  type: control

keywords:

seq lfo phasor saw

Authors: Serge Poltavsky

License: GPL3 or later